Miele G2000 - Page 154

Technical Information
154
G1000 / G2000 Dishwashers
Flashing
Rhythm of
Delay Start
LED
Function Programming Display
Flashing Rhythm of
Rinse LED
Long Short Long Short Display
- - P0
2 1
Pos. 21:
Final rinse
temperature
modification
(from
software
version ID
No. –984)
Press the Delay start
button 21 times. The
Delay start LED
flashes 2 times slowly
and once rapidly
intermittently. Press
the Start/Stop button
as appropriate to
make the desired
setting.
The Rinse LED is off
or flashes. The
display shows P and
a digit alternately: P0
= Standard setting;
P1 = Final rinse
temperature
increased. Due to a
program-dependent
running time
extension, the final
rinse temperature will
be increased.
- 1 P1
Long Short Long Short Display
- - P0
2 2
Pos. 22:
Program
running time
reduction
(from
software
version ID
No. –984)
Press the Delay start
button 22 times. The
Delay start LED
flashes 2 times slowly
and 2 times rapidly
intermittently. Press
the Start/Stop button
as appropriate to
make the desired
setting.
The Rinse LED is off
or flashes. The
display shows P and
a digit alternately: P0
= Standard setting;
P1 = Program
running time
reduction.
- 1 P1
Long Short Long Short Display
- - P0
2 3
Pos. 23:
Water
quantity
normal /
increased
(from
software
version ID
No. –876)
When the decimal
point in the display
has switched off,
press the Delay start
button 23 times. The
Delay start LED
flashes 2 times slowly
and 3 times rapidly
intermittently. Press
the program button
as appropriate to
make the desired
setting.
The Rinse LED is off
or flashes. The
display shows P and
a digit alternately: P0
= Normal water
quantity (standard
setting); P1 =
Increased water
quantity.
- 1 P1
Long Short Long Short Display
- - P0
2 4
Pos. 24:
Soak
activation /
deactivation
(from
software
version ID
no.-818)
Press the Delay start
button 24 times. The
Delay start LED
flashes 2 times slowly
and 4 times rapidly
intermittently. Press
the Start/Stop button
as appropriate to
make the desired
setting.
The Rinse LED is off
or flashes. The
display shows P and
a digit alternately.
Setting options: P0 =
Soak not activated;
P1 = Soak activated.
- 1 P1
Table 6-33: G2420 / G2430 Programming Mode Options (Cont. from Table 6-32) (Cont. on Table 6-34)