Need help?Do you have a question about the Miele T 80 Series and is the answer not in the manual?
General| Appliance Category | Dryer |
|---|---|
| Brand | Miele |
| Capacity | 7 kg |
| Control Type | Electronic |
| Number of programs | 12 |
| Color | White |
| Loading Type | Front Loading |
| Drying Programs | Cottons, Minimum iron, Delicates, Woollens handcare, Silks, Shirts, Dark garments, Denim, Outerwear, Proofing, Warm air, Cool air |
| Series | T 80 Series |
| Dimensions (H x W x D) | 850 x 595 x 580 mm |
General safety precautions and warnings for working on the appliance.
Risks associated with excessive lint buildup and potential fire hazards.
Procedure for correctly restoring the ground connection after panel removal.
Diagram and explanation of the dryer's control panel interface and indicators.
Illustration and labeling of components for specific dryer models.
Illustration and labeling of components for specific dryer models.
Illustration and labeling of components for specific dryer models.
Illustration and labeling of components for specific dryer models.
Step-by-step guide to safely remove the dryer lid for access.
Instructions for removing the toekick and front panel.
Procedures for removing side panels and the metal support bracket.
Explanation of how the door lock operates and its safety switch.
Steps for removing the door assembly and the door lock mechanism.
Details on residual moisture sensing, NTC sensors, and drum light.
Troubleshooting guide for tripped temperature limiters and related causes.
Procedures for removing the heater bank, NTC, and rear bearing.
Explanation of fan orientation and its impact on performance.
Procedures for removing drum ribs and contact strips.
Steps for replacing the fan impeller and the motor/drive assembly.
Procedures for removing the fill-ring NTC and the air shield.
Steps for removing and replacing the extractor module.
Explanation of how the heat exchanger removes moisture from drying air.
Detailed steps for removing the condensate box assembly.
Procedure to remove the rear service panel for access.
Step-by-step guide to remove and replace the condensate pump.
Adjusting residual moisture levels and other programming functions.
Accessing software status, fault memory, and component tests.
Troubleshooting common fault codes and LED indicators.
Instructions for removing and replacing heater relays.
Procedure for removing the RemoteVision module.
Information on different dryer ducting types, benefits, and limitations.
Guidelines for calculating maximum allowable duct length based on bends and fittings.
To Next Page
