Miele T 80 Series - Activating;Deactivating the Demonstration Mode; Table 090-4: Programming Mode Summary

Technical Information
57
T 80xx
Programming function (use “Buzzer” button) Option (use “Start/Stop” button)
“Buzzer” LED long short “Drying” LED short
Reset
-- 1
Settings were
changed (to reset the
programming
functions to factory
settings, press the
Start/Stop button
until the “Drying” LED
flashes)
-
Delivery condition
1
Normal drying
outcome (residual
moisture)
-- 2
Standard drying
outcome
-
More dry in normal
programs
1
Wrinkle-free drying
outcome (residual
moisture)
-- 3
Standard drying
outcome
-
More dry in wrinkle-
free programs
2
Memory
-- 6
Off, memory function
not activated
-
On, memory
function activated
1
Additional cooldown
phase
-- 7
Off
-
+5 min 1
+10 min 2
Insufficient air alert
(prompt “Filter/Vent”
LED)
1 --
Off -
Less sensitive 1
Standard
2
More sensitive 3
Button tones
1 1
Off -
On
1
Table 090-4: Programming Mode Summary
Save and quit:
Shut the dryer off.
4.2 Activating/Deactivating the Demonstration Mode
Initial requirements:
1. End the current program.
2. Switch the dryer off.
3. Close the door.
Accessing:
Note: Access has to be completed within 10 seconds.