Technical Information
16
T 80xx
4.2 Toekick Removal
1. Disconnect the appliance from the power supply.
2. Remove the screw caps using a flathead screwdriver. See Figure 010-1.
3. Remove the two T20 screws securing the toekick.
4. Take off the toekick.
4.3 Removing the Front Panel
1. Disconnect the appliance from the power supply.
2. Remove the toekick. See Section 010-4.2.
3. Open the door.
4. Remove the five T20 screws around the fill ring and the two T20 screws
securing the door lock. See Figure 010-1.
5. Close the door.
6. Holding the front panel securely, remove the two T20 screws securing the
bottom outer corners of the front panel. See Figure 010-1.
7. Remove the front panel from the machine.
4.4 Side Panel Removal
1. Disconnect the machine from the power supply.
2. Remove the lid; refer to Section 010-4.1.
3. Remove the toekick; see Section 010-4.2.
4. Remove the front panel; refer to Section 010-4.3.
5. Remove the side panel retaining screws (up to nine T20s per panel). See
Figure 010-1.
6. Take the side panel(s) off.
4.5 Metal Support Bracket Removal
1. Disconnect the appliance from the power supply.
2. Remove the lid; refer to Section 010-4.1.
3. Take out the condenser box.
4. Remove the fascia panel; see Section 090-4.4.
5. Remove the electronic; see Section 090-4.5.
6. Remove the electronics support bracket (plastic); see Section 090-4.6.
7. Remove the four T20 screws securing the corners of the metal support
bracket (Figure 010-2).
8. Release the metal support bracket from the appliance chassis.
To Next Page
Loading...
Need help?
General
