Miele T 80 Series - End;Anti-Crease LED Lights up; Container LED Lights up

Technical Information
49
T 80xx
Note:
If the electronic lock function has been successfully deactivated, the
“Child Lock” LED will no longer flash.
Note:
To activate/deactivate the electronic lock function, also see the operating
instructions.
3.2 “End/Anti-Crease” LED Lights Up
Symptom:
Only in residual-moisture programs.
Program stop.
Cooldown.
Buzzer intermittently for 2 minutes.
Cause:
The drum is empty or the laundry is too dry (no-load detection). No fault. For
no-load detection, refer to Section 090-2.4
Remedy:
1. Add laundry.
2. Use a timed program.
Cause:
Residual-moisture sensor (B3/1) defective.
Remedy:
Check the residual-moisture sensor (B3/1) for low ohmic status; refer to
Section 090-4.3.
Note:
To delete this fault indication, open and close the door with the dryer
switched on.
3.3 “Container” LED Lights Up
Symptom:
Program stop.
Cooldown.
Buzzer intermittently for 2 minutes.
Cause:
Condenser models only: The condensate tank is full. No fault.
Remedy:
Empty the condensate tank.
Cause:
Condenser models only: The condensate drain line is clogged or kinked,
and the condensate cannot be drained off.
Remedy:
Check the condensate drain.