Technical Information
45
T 80xx
1 Technical Data
Control technology
Single-board
control: control/power
electronic (1N1)
Vented dryer: EPWL 315
Condenser dryer: EPWL 314
1
T 8019CI: EPWL 316-DI
Programs are update-capable via optical
PC interface
RemoteVision-ready
Drying technology
Tangle prevention
Reverse cycles are controlled by a random
generator.
Residual moisture
sensing
Conductivity-measuring
process, residual moisture sensor (B3/1)
Insufficient-airflow
detection
Via heater NTC (2R30) and fill-ring NTC (1R30)
Table 090-1: Technical Data
1
Condenser versus vented dryer: In the condenser dryer, the electronic also has a plug
for the condensate float switch (B8/7).
2 Function
2.1 Programming Functions
2.1.1 Resetting to Factory Settings
Resets all programming options to their factory settings.
Note:
The reset takes effect immediately; it's not possible to restore the previous settings!
Operating hours are not reset.
Not possible with service-department electronics supplied as spare parts.
2.1.2 Residual Moisture Level Adjustment - Normal Wash
Normal Standard Reduced moisture (drier)
Extra dry -4% -5%
Normal + -2% -3%
Normal 0% -1%
Hand iron ° 8% 6%
Hand iron °° 12% 10%
Rotary iron 20% 16%
Table 090-2: Residual Moisture Level Adjustment - Normal Wash
2.1.3 Residual Moisture Level Adjustment - Wrinkle-Free
Wrinkle-free Standard Reduced moisture (drier)
Normal + 0% -1%
Normal 2% 1%
Hand iron 8% 6%
Table 090-3: Residual Moisture Level Adjustment - Wrinkle-Free
To Next Page
Loading...
