Technical Information
46
T 980x/T 982x
4 Service
4.1 Air Shield Removal
1. Disconnect the machine from the power supply.
2. Remove the dryer lid; refer to Section 010-4.1.
3. Remove the fascia, the electronic, and the electronic's support panel;
refer to Section 090-4.4.
4. Remove the front panel; refer to Section 010-4.2.
5. Remove the right side panel; refer to Section 010-4.3.
6. Remove the two T20 screws securing the top and left side of the metal
bracket in front of the air shield.
7. Remove the four T20 screws securing the sides of the air shield. See
Figure 050-2, Item 1.
8. Prop up the front of the drum to reduce any strain on the rear bearing.
9. Remove the T30 screw securing the right side of the fan cover (use a
ratchet with a 10-inch extension, if necessary). See Figure 050-2, Item 2.
10. Remove the T30 screw securing the bottom of the fan cover (use a
ratchet with a 10-inch extension). See Figure 050-2, Item 3.
11. Lift the air shield up slightly, release it from the casing, and pull it down
and out; disconnect any electrical connections.
Figure 050-2: Air Shield Removal
To Next Page
Loading...
