EasyManua.ls Logo

Miele T 980x - Laundry Is Overdried;F55 (Overriding Time Limit Exceeded); Dryer Shuts Itself off

Miele T 980x
67 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Technical Information
59
T 980x/T 982x
3.16 Laundry Is Overdried/F55 (Overriding Time Limit Exceeded)
Symptom:
Very long operating time.
F 55 is stored in the fault memory.
Cause:
Short circuit at drum contact strip.
A metal bracket of the drum contact strip is touching the drum casing and has
caused a short circuit. Therefore, the electronics are detecting moisture, even
though the laundry is already dry.
Remedy:
Insulate the bracket from the drum casing by placing an insulating sleeve
(mat. no. 07244210) around the bracket.
Note:
In order to clear this fault message, open and close the door with the
appliance switched on.
3.17 Dryer Shuts Itself Off
Symptom:
Dryer shuts itself off suddenly during operation.
No fault message; no additional symptoms.
Cause:
Not enough supply voltage available.
See Section 090-2.9.
Remedy:
No remedy needed, because the electronics will switch the dryer on again
when they have detected sufficient voltage.
Cause:
The electronic prematurely detects a low voltage.
The values for low-voltage detection have been adjusted. For current low-
voltage detection values, see Table 090-3.
Remedy:
Measure the input voltage to determine if the dryer has shut off in accordance
with the values shown in the table. If possible, measure the voltage while a
drying program is running and heating is switched on.
If the dryer has shut off prematurely, replace the electronic.

Table of Contents

Related product manuals