OM-277115 Page 60
D. Wired (Ethernet) Connection Using Static Addressing
1. On the Setup page, under Ethernet Settings, click Edit.
2. At the top of the screen that appears, select Static under the IP address.
3. Under Network Information, enter your IP address, subnet mask, and network gateway. This information is found on the Network Connectivity
Survey completed by your IT Department (see Section 10-2).
4. Under DNS Address, select DNS Server. Enter DNS address from the Network Connectivity Survey completed by your IT Department (see
Section 10-2).
. Double-check the numbers before saving. A wrong number may be difficult to correct.
5. When finished, click Save All.
6. Cycle the machine power by turning the machine off, waiting until the Power On light goes off, and turning power on again.
Figure 10-10. Configuring Ethernet Connection Using Static Addressing
Notes
To Next Page
Loading...
