Miller Syncrowave 210 - Removing Power Pin Style Connector to Adapt Spoolmate 100;150 Models; Installing Dinse Style Connector to Adapt Spoolmate 100;150 Models

. A complete Parts List is available at www.MillerWelds.com
OM-261726 Page 16
5-5. Removing Power Pin Style Connector To Adapt Spoolmate 100/150 Models For Use
With The Syncrowave 210
! Turn Off welding power source and
disconnect spool gun.
Photo 1 −Power Pin Style Connector
Power pin style connector that comes stan-
dard with the spool gun must be changed to
a Dinse style connector for use with the Syn-
crowave 210.
4 Strain relief
Turn strain relief cap 1/4 turn counter clock-
wise, and slide strain relief down cable.
5 Phillips Screw
6 Handle
Remove screw, and handle.
7 Power Pin Connector
Use 13 and 17 mm wrenches to remove pow-
er pin style connector.
1
4
2
3
5-6. Installing Dinse Style Connector To Adapt Spoolmate 100/150 Models For Use With
The Syncrowave 210
! Turn Off welding power source and
disconnect spool gun.
1 Dinse Style Connector
Screw on Dinse style connector and tighten
with 13 and 17 mm wrenches.
Slide handle back into position, and secure
with Phillips screw removed earlier.
Slide strain relief into position, and tighten
strain relief cap.
1