Miller Syncrowave 210 - Accessing User DC Stick Setup Menu

. A complete Parts List is available at www.MillerWelds.com
OM-261726 Page 28
6-7. Accessing User DC Stick Setup Menu
1 Menu Button
Press and hold Menu button for ap-
proximately 2 seconds to access
machine configuration menus. Use
Menu button to cycle through para-
meters that can be set.
2 Parameter Display
3 Setting Display
4 Encoder
Rotate Encoder to adjust parameter
setting.
Arc Starting Method Selection:
[OCV] [NORM]
Normal open circuit voltage for arc start-
ing.
NORM
OCV
268890-B
[OCV] [LOW]
Low open circuit voltage for arc starting.
USER
2
3
4
1MENU