Milli-Q Millipore - Replacing the Quantum Cartridge: Installation

Milli-Q® Reference System 65
Replacing the Quantum® Cartridge, Continued
Placing
Follow the steps below to install a new Quantum® Cartridge.
Step
Action
Diagram
1
Remove the covers on the 2
ports of the Quantum®
Cartridge.
Wet the O-rings with water.
2
Install the Quantum® Cartridge
until it is fully seated.
Close the right door.
3
When a new Quantum®
Cartridge is installed, the LCD
looks like this.
4
Press .
Proceed to the next set of steps to rinse the Quantum® Cartridge.
Continued on next page