Millipore ICW-3000 - 4-9 INSTALLATION OF THE TYGON TUBING

INSTALLATION
- 15 -
4-9 INSTALLATION OF THE TYGON® TUBING
 Locate the clear Tygon Tubing and the Barbed Fitting in the Accessories Bag.
 Screw the Barbed Fitting onto the bottom end of the POU Dispenser (A).
Do not use any white tape on the threads of the
Barbed Fitting. An O-ring is located inside the
POU Dispenser to ensure water tightness between
the threads of the POU Dispenser and the Barbed
Fitting.
 Push one end of the Tygon Tubing onto the end of the Barbed Fitting (B). Place the other end of the
Tygon Tubing in a sink.
A
B
ATTENTION