Millipore ICW-3000 - Chapter 2 PRODUCT INFORMATION; 2-1 ICW-3000 SYSTEM OVERVIEW; 2-2 ICW-3000 SYSTEM PRODUCT WATER SPECIFICATIONS

PRODUCT INFORMATION
- 3 -
Chapter 2 PRODUCT INFORMATION
2-1 ICW-3000 SYSTEM OVERVIEW
The ICW-3000 Water Purification System is designed to be connected to 1 or 2 ion chromatography systems
(combined to an eluent generator). The ICW-3000 System distributes water to the ion chromatography
system on both suppressor and eluent generator inlets.
Pre-treated pure water (Elix® or distilled) is supplied from a tank to the ICW-3000 System to produce
ultrapure water.
The display is used to
monitor the Product
Water quality and system
status.
The keypad is used to access
operating functions and system
settings and to dispense Product
Water.
2-2 ICW-3000 SYSTEM PRODUCT WATER SPECIFICATIONS
WATER FLOW RATE SPECIFICATION
PARAMETER SPECIFICATION
Eluent Flow ≥ 4 ml/min
Eluent Pressure ≥ 0.2 bar (3 psi)
Suppressor Flow ≥ 20 ml/min
Suppressor Pressure ≥ 1.7 bar (25 psi)
Water Dispensing from POU (1) ≥ 250 ml/min
(1) With new Millipak express 20
PRODUCT WATER QUALITY
Type 1 (Ultrapure) water
PARAMETER SPECIFICATION (1)
Product Water Resistivity (1) 18.2 MΩ.cm at 25°C
Product Water TOC (2) < 5 ppb
(1) Product water quality specifications are achievable only if feed water quality is within
specifications and for typical operating conditions (after at least 1 day of regular operation)
(2) TOC values given for Eluent and Suppressor lines after complete hydratation and rinsing of the
SimpliPak® Cartridge.
DISPLAY
KEYPAD