- 5.17 -
9. Press the [
] and [ ] key, select the time to
leave. (1-99 mins: 1 min unit)
Normally set 1 min.
10. Close the front cover, and push the [ENTER]
key.
Perform the nozzle cleaning.
11. After completing the nozzle cleaning, the head
moves on the platen.
Open the front cover.
12. Fill the cap with the cleaning fluid using a
pipette.
Repeat the performance several times to clean the ink
discharge way for the air aspiration is performed fitfully.
Perform the operation for the each cap.
13. Close the front cover, and push the [ENTER]
key.
Carriage returns the device to LOCAL mode.
STATION
LEAVING : 2 min
INITIALIZING
PLEASE WAIT
STATION
COMPLETED : ent
< LOCAL >
To Next Page
Loading...
