MIMAKI JV3-160S - Setting Suitable Heater Temperature

- 4.10 -
Lower the heater
temperature
Press jog keys to
move the medium
back and forth
Setting suitable heater temperature
The following describes the procedure for setting the suitable heater temperature at the time of
heater temperature depends on the medium type and ambient temperature. (
page 2.18,4.5)
Set a temperature which is suitable for each medium. Non-coated media and media with a long ink
drying time improve the ink fixing and drying characteristics.
Set a suitable heater temperature with the following procedure.
Set the heater temperature page 2.18
Leave until the CONSTANT indicator goes on.
Is medium wrinkled?
Does medium stick to platen?
Correct the medium feed rate page 2.22
Make test plotting.
Does beading occur?
End
Raise the heater
temperature
Initially, set a high
temperature