- 5.3 -
Setup functions
The following describes the overview of and settings for each function.
Name Function
STATION Clean the inside of the station and replace the wiper.
( WIPER EXCHANG, CARRIAGEout )
INT.WIPING
PRINT ADJUST Adjust the dot position according to the head height, high/low.
FILL UP INK Perform this function if nozzle clogging is resolved after head cleaning.
WASH Perform this function if nozzle clogging is resolved after head cleaning.
Disway WASH Wash the ink discharge way (from the ink cap to the waste ink tank).
SLEEP clean Perform head cleaning and flushing operation to prevent from nozzle-out phenom-
enon.
CUSTODYwash When not in use the plotter over a week, perform the function to wash the head
nozzle and ink discharge way.
LIST Plotting the set condition of the device.
DATA DUMP Plotting data commands received from the computer, in HEX code.
WIPE LEVEL Makes setting to move up the wiper replacement warning depending on the
operating environment.
TIME SET Sets the date and time of the built-in calender of the device.
INFORMATION Displays the firmware version, serial number, and dealer number of the device.
page 5.4
through 5.6
page 5.7
page 5.9
page 5.11
page 5.11
page 5.13
page 5.15
page 5.16
page 5.18
page 5.19
page 5.20
page 5.21
page 5.22
To Next Page
Loading...
