- 6.6 -
< LOCAL >
DO TEST DRAW
NON-ORIGINAL INK
KMCYmc
The nozzle recovery cannot be
expected because the device is
left for a prolonged period of
time.
The loaded ink cartridge is not
MIMAKI genuine.
Make test plotting. If nozzle
missing is serious, execute [STA-
TION] - [WASH] for maintenance.
Use the ink specified by MIMAKI.
Warning message Cause Corrective measure
WRONG INK IC
KMCYmc
The IC chip of the ink cartridge
cannot be read normally.
The type of the loaded ink
cartridge is different from the
previous one.
The color of the loaded ink
cartridge is different from the
previous one.
The loaded ink cartridge is
defective.
The ink cartridge is not attached
to the ink station.
Attach the ink cartridge(s)
corresponding with the color
shown on the display. If the same
error message appears again on
the LCD, contact your local
distributor to call for service.
Check the type of the loaded ink
cartridge.
Check the color of the loaded ink
cartridge.
Check the loaded ink cartridge.
KIND OF INK
KMCYmc
INK COLOR
KMCYmc
WRONG CARTRIDGE
KMCYmc
NO CARTRIDGE
KMCYmc
<LOCAL> ! HEATER
width: xxxxx mm
∗ REMOTE ∗ ! HEATER
TYPE. 1 0.0 0 m
Heater Power OFF
Pre 40°
45° C
Print BREAKAGE
Pre BREAKAGE
Print 43° C ( 4 7)
The preheater or print heater has
failed.
Attach the ink cartridge(s)
corresponding with the color
shown on the display.
Press the [HEATER] key to
display the details of the error.
Check the error.
The power of the heater is off.
The print heater is disconnected.
The preheater is disconnected.
Turn on the power of the heater.
If the same error message appears
again on the LCD, contact your
local distributor to call for
service.
Contact your local distributor to
call for service.
To Next Page
Loading...
Need help?
General