- 1.4 -
Configuration and function
The Front
Name Function
1 Front cover It is opened when setting medium or taking a corrective measure against
a medium jam. Even if the power switch is off, keep the front cover
closed to perform the ink clogging preventive operation.
2 Carriage Moves the print head from side to side.
3 Operation panel This panel has the operation keys required for operating the device and
the LCD for displaying set items, etc.
4 Capping station Incorporates the ink cap to be capped on the head and the wiper, etc.
5 Clamp lever It is made to go up-down the pinch roller for holding medium.
6 Heater operation panel Provides the heater power switch and the heater status LED indicator.
7 Power switch It turns on/off the power to the device.
When the power switch is turned on, the POWER indicator lights in
green. While the main power switch is on, the ink clogging preventive
operation is performed periodically even if the power switch is off.
(Flashing)
8Waste ink tank Waste ink gathers in this tank.
9 Stand It supports the main unit. It is provided with casters that are used to
move the device.
10 Take-up device It supports to wind up the roll medium printed.
11 Voltage selector switch Switches between 100-120 V and 220-240 V according to the power
voltage used.
12 Platen It puts out the medium as it is plotted on.
13 Printer heater Fixes and dries printing ink. ( Attached inside the platen )
14 Front exhauster Discharges plotting smell from the medium to out of the room.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
To Next Page
Loading...
