- 2.6 -
Adjusting the head height
The head can be adjusted in height in two different stages, upper and lower, according to thickness
of a medium used for plotting.
This adjusting function enables the device to respond to light-weight medium such as paper and film
and heavy-weight medium such as tarpaulin as thick as 0.5 mm.
• Adjust the head height before placing a medium on the device. If the head
height has been set for light-weight media when a heavy-weight medium is
to be placed on the device, moving the carriage from the capping station for
adjusting the head height after the medium is placed on the device can
cause paper jamming or head breakage.
•When in bidirection mode, adjust the head height before executing print
adjust in the maintenance function. Page 5.9
• According to the adjusted head height, set the head height (high/low).
Page 4.9
Medium Height adjusting lever
PVC
Tarpaulin
FF
Thin : light-weight
Thick : heavy-weight
• Set the lever to the lower stage (Thick) if dust is likely to gather in the head
or the head is likely to rub the medium to leave ink on it.
To Next Page
Loading...
