- 1.5 -
The REAR
Name Function
1 Rear exhauster Discharges plotting smell from the medium to out of the room.
2 Ink station Set the ink cartridges specified.
3 Ink cartridge Each cartridge contains ink of a specific color.
4 Parallel connector Bi-directional parallel interface connector (complies with IEEE1284)
5 IEEE-1394 connector A 400M bps interface connector compatible with IEEE-1394.
6 Paper roll setting bar This bar facilitates a paper roll to be set in position.
7 Roll holder Roll holder is inserted in the right and left core of roll medium to hold
the roll medium. The roll holder is applicable to diameter of medium
cores with 2 and 3 inches. The attachment position (height) of the roll
holder can be set in three steps. To increase the heater contact time,
attach it at the bottom position.
8 AC inlet The power cable is connected to the AC inlet.
9 Main power switch Turns on/off the main power of the device. Leave the main power turned
on to prevent ink clogging.
10 Clamp lever Works together with the clamp lever on the font face of the device.
11 Preheater Preheat the medium before plotting. ( Attached inside the platen )
1
2
3
7
4
6
3
8
2
10
11
9
5
To Next Page
Loading...
