- 4.9 -
VACCUM
Sets the absorbability of the medium. If the medium tends to stick to the platen, select LOW.
(STANDARD, LOW, OFF)
MM / INCH
Set a unit of set values displayed.
(MM, INCH)
STAMP
Prints the date of output and plotting condition at end of plotting.
MODE STAMP :
Print the plotting condition.
(ON, OFF)
TIME STAMP :
Print the date of output.
(ON, OFF)
AUTO CLEANING
The head is cleaned automatically. Perform cleaning for each plot to prevent plotting failures.
(ON, OFF)
HEAD HEIGHT
Adjust the head height.
Select the correction value (low, high) for the head height registered by PRINT ADJUST during
maintenance.
(LOW, HIGH)
page 5.9 PRINT ADJUST
SETUP RESET
This function resets the current plotting conditions to the factory-set plotting conditions.
Execute this function for each of the types of set plotting conditions.
To Next Page
Loading...
