- 6.1 -
CHAPTER 6
When abnormal conditions are
encountered
Chapter 6 describes corrective measures to be taken in the case where an abnormal
phenomenon arises on the device and where an error message is given on the display.
Table of contents
Before taking a phenomenon as a sign of failure .......................................... 6.2
The device cannot be energized ..................................................................... 6.2
The device cannot perform printing ................................................................. 6.2
Paper jamming arises/medium is soiled .......................................................... 6.3
The [HEAT] or [CONSTANT] indicator does not go on .....................................6.3
If image quality declines ................................................................................ 6.4
While lines/thin spots are obvious or dark stripes occur (In the direction of travel
of the head) ..................................................................................................... 6.4
Characters fluctuate doubly or triply into paper feed ....................................... 6.4
Displacement is observed between outward and inward printing ................... 6.4
The respective color ink injected by the respective color heads do not properly
overlap............................................................................................................. 6.4
Large ink drop on medium............................................................................... 6.4
Troubles for which error messages are given on the LCD ............................ 6.5
Errors accompanied by warnings .................................................................... 6.5
Error messages ............................................................................................... 6.8
To Next Page
Loading...
