- 2.13 -
13. Set an empty paper tube to the take-up device.
14. Close the front cover and push the [ENTER]
key.
The width of the medium is detected.
Press the [
] jog key to feed the medium up to the paper
tube position of the take-up device.
15. Fix the medium to the empty paper tube using
an adhesive tape.
• Check that there is no slack or wrinkle, caused
by uneven tension, on the roll medium in the
range between the roll holder and the platen.
While pulling the roll medium from side to side
evenly, clamp the lever.
• If the roll medium used is wide, the edges of the
paper may get loose from the platen during
plotting. Use the media plate to hold down the
edges of the medium. This prevents the medium
from being stained with the ink by getting loose
from the platen.
• When using a thick medium, remove the media
plate from the medium before plotting.
To Next Page
Loading...
