- 5.1 -
CHAPTER 5
Maintenance
In order to keep the plotter in good operating condition, it is necessary to carry out
maintenance of the device periodically.
This chapter describes the functions that help solve the problem of deterioration in
image quality and replace a worn cutter blade.
The device needs maintenance when it is left out of operation for a long period of
time.
Table of contents
Maintenance of the device ............................................................................ 5.2
Invoking a maintenance function ..................................................................... 5.2
Setup functions.................................................................................................5.3
Cleaning the station interior [STATION]-[CARRIAGEout] ............................. 5.4
When the message [REPLACE WIPER] is displayed ................................... 5.5
[STATION]-[WIPER EXCHANGE] ................................................................. 5.5
Regular wiping function [INT.WIPING] .......................................................... 5.7
When medium thickness is changed [PRINT ADJUST] ................................ 5.9
If nozzles are clogged even after the cleaning function is executed ........... 5.11
[FILL UP INK] ................................................................................................. 5.11
[WASH] ........................................................................................................... 5.11
Ink discharge way cleaning [Disway WASH] ............................................... 5.13
Sleep cleaning [SLEEP clean]..................................................................... 5.15
When not in use the plotter over the long term [CUSTODYwash] .............. 5.16
Drawing setup conditions [LIST].................................................................. 5.18
Plotting HEX CODE [DATA DUMP] ............................................................. 5.19
Wiper Life warning [WIPE LEVEL] .............................................................. 5.20
Setting time [TIME SET] .............................................................................. 5.21
Displaying device information [INFORMATION] .......................................... 5.22
Replace the cutter blade for cutting............................................................. 5.23
To Next Page
Loading...
