- 5.10 -
• If the pattern correction value for straight lines is
not within -40 through +40, adjust the head height
and then correct it again with [PRINTADJUST].
6. Push the [ENTER] key.
7. Repeat Steps 5 and 6 to correct the dot posi-
tions on Patterns 2 to 7.
Select the correct dot positions on each of the patterns.
Enter the dot position correction value on Patterns 1 to 7 and
then terminate dot position correction.
8. Push the [END] key twice, and the menu re-
turns to the LOCAL mode.
After the dot positions are corrected, select the head height
(LOW, HIGH) according to the setting function type. The
correction value of the head height (low, high) becomes valid.
page 4.9
MAINTENANCE
PATTERN 2 = 0. 0
MAINTENANCE
PATTERN 3 = 0. 0
MAINTENANCE
PATTERN 4 = 0. 0
MAINTENANCE
PATTERN 5 = 0. 0
MAINTENANCE
PATTERN 6 = 0. 0
MAINTENANCE
PATTERN 7 = 0. 0
< LOCAL >
width : 1272 mm
Out put direction
Select the dot positions 4.0 that
make a straight line on the test
pattern in two plotting direction.
To Next Page
Loading...
