MIMAKI JV300-160 A - Page 86

Chapter5 Troubleshooting
5-10
SYSTEM HALT
Due to a certain error, the function can-
not be performed.
• Return to the local screen, check the error
status and take a countermeasure.
There remains received data that has
not yet been printed.
• Execute the data clear function. ( P.2-13)
An error occurred in the mounted heads.
• Turn the main power off once and turn it
back on after some time.
• If it is displaying again, contact your local
distributor, our sales office or our call center.
The media width or the media length
required for printing is not enough.
• Change the media to the one with enough
width or length.
• When the media width narrows because the
origin moved, slide the origin to the right to
widen the effective media width.
An error occurred in the main PCB
FROM.
• Turn the main power off once and turn it
back on after some time.
• If it is displaying again, contact your local
distributor, our sales office or our call center.
Message Solution
• Turn the main power off once and turn it back on after some time.
If it is displaying again, check the number and contact your local distributor, our sales
office or our call center. (“000” is the error No.)
• Perform cleaning around the wiper.
• Turn the main power off once and turn it back on after some time.
If it is displaying again, check the number and contact your local distributor, our sales
office or our call center.
Message Cause Solution
ERROR 901
INVAILD OPERATION
ERROR 902
DATA REMAIN
ERROR 90d
NO HEAD SELECT
ERROR 90f
PRINT AREA SHORT
ERROR 04
PARAM ROM
SYSTEM HALT (*)
000 : MESSAGE
SYSTEM HALT (*)
406 : WIPER ORG