Overhaul of Driving Parts
3-41
10
Align the belt holder 1 and the teeth on
the left and right belt ends, and attach
the belt holder 1 engaging the teeth and
tighten the screw.
11
Join the left and right belt holder 1 to the belt holder.
12
Attach the belt holder and slider using a screw.
13
Loosen the screws (x2) on the Y-SP plate on the left side panel of the main unit, and increase the Y
drive belt tension.
Belt holder 1 (M400160)
Engage the toothed surface of belt with
belt holder 1.
To Next Page
Loading...
