MIMAKI JV33-160 - Page 36

Color Inkjet Printer JV33-130/160
2-24
SERIAL No
 Contents: Confirmation and setting of serial ID.
8 characters of alphabet and numeral (0~9, A~Z) can be input.
 Key operation
[], []:Change value (cursor position)
[], []:Moving the cursor
(When the cursor is in the left end or the right end, key input does not work)
[ENTER] :Setting
[END] :Input cancel
DEALER No
 Contents: Confirmation and setting of dealer ID.
8 characters of alphabet and numeral (0~9, A~Z) can be input.
 Key operation
[], []:Change value (cursor position)
[], []:Moving the cursor
(When the cursor is in the left end or the right end, key input does not work)
[ENTER] :Setting
[END] : Input cancel
EDGE ADJUST
 Contents:Adjust dead space size of both left and right ends of paper
 Key operation
[]:Set adjust value of L, R to default (15.0 mm).
[]: Execute media width detection to draw an adjust pattern.
[], []:Change adjust values
[END] :Input cancel
 Adjust value:0.0~35.0 mm (unit: 0.1 mm)
Input actual measurement from media end to the pattern as an adjust value.
If the unit is changed to inch, convert the value to inch to adjust.
Fig.2-5
Note: The set value is stored in the system parameter No.2 R GRIP, No.3 L GRIP as “current parameter value + (15 mm-input
value)”.
Cannot be changed if the serial number is set.
Media width
15 mm 15 mm