Color Inkjet Printer JV33-130/160
3-22
Download Parameters
1
Start JV33 with parameter Up/Down
load Mode.
Turn the power ON with pressing []+[].
2
Start the FWUpdateTool3.
Connect the JV33 and PC by USB cable, and
run the FWUpdateTool3.
3
Select the interface in the [Download]
tab of the FW Update Tool III screen.
In [Device] section, check the interface con-
necting printer.
4
Select [JV33.PRM] from the [PRM File]
list.
5
Select the file to upload.
Click the [Browse] button, and select the file
that was uploaded before replacing the main
PCB.
6
Execute [Download!!]
7
The screen in the diagram on the right is
shown during downloading.
Click [Abort] button to cancel.
8
Check that the operation completed nor-
mally.
A completed dialog box is displayed if the oper-
ation completed successfully.
Click [OK] button.
Up & Download mode
Power ON
Up & Down load Ready!
To Next Page
Loading...
