MIMAKI UJV100-160 - Cap Replacement

Chapter 4 Maintenance
105
6
Insert a new wiper.
Lug
7
Press the [ENTER] key once replacement is complete.
8
Close the front cover, then press the [ENTER] key.
• The wiper usage count is reset.
Cap Replacement
If print defects (e.g., nozzle clogging, deflection) remain unresolved even after cleaning, replace with a new
cap.
• Be sure to replace the cap if you observe any scratches or other damage on the rim.
1
In LOCAL mode screen, select [MENU] > [Maintenance], then press the [ENTER] key.
• The Maintenance menu is displayed.
2
Select [Station] > [Carriage Out] > [Move To Platen Right End ], then press the [ENTER] key.
• The carriage moves over the platen.
3
Open the front cover.
4