MIMAKI UJV100-160 - Setup Menu; Setup Menu List

Chapter 3 Settings
72
3.1 Setup Menu
Print conditions (settings 1 to 4) can be saved in advance for specific media.
l
Setup menu screen
Select“SETUP1to3”or“Tempotary”
andthenpressthe key
width:1340mm
REMOTEMENU
TEST PRINT
CLEANING
LOCALMENU
SETUP
>
>
MAINTENANCE
>
INFORMATION
>
NOZZLECHECK
>
MACHINESETUP
SETUP
●SETUP1
>
>
○SETUP2
>
○Temporary
>
○SETUP4
>
○SETUP3
SETUP11/3
>><< >><<
SETUP12/3
SETUP13/3
>><<
VACUUMFAN
HOST
100％
FEEDSPEED
>
AUTOCLEANING
OFF
UVMODE
MAPS4
>
RESETSETTIG
>
FEEDCOMP.
>
>
DROP.POScorrect
>
AUTO-CORRECTION
HOST
MARGIN/LEFT
HOST
MARGIN/RIGHT
HOST
LOGICALSEEK
HOST
OVERPRINT
Setup Menu List
The user can select to prioritize the settings on the machine or the settings on the PC. Setting individual
menus to “HOST” prioritizes PC settings. To prioritize settings for this machine, select a setting other than
“HOST”.
• For more information on how to specify RIP software, refer to the RIP software operating
manual.
Item Setting Details
*1 *2
Feed Comp. -9999 to 0 to
9999
- Corrects the media feed amount.
• Print a pattern and enter the correction amount.
Drop.PosCorrect -40.0 to 0 to
40.0
- Corrects the drop position for bi-directional printing.
• Print a pattern and enter the correction amount.
Auto Correct - - Detects a correction pattern with the sensor and automatically
corrects the drop position.
• Check to confirm that the media does not lift up.
• Load white and clean media.
• Synthetic paper or cloth media may not be detected.
• Do not send the RIP data from the PC during pattern printing.
• If automatic correction is unsuccessful, correct the position
manually. [MENU] > [SETUP] > [Feed Comp.] or
[Drop.PosCorrect]
Feed Comp. - -
Drop.PosCorrect - -
Logical Seek HOST/OFF/
ON
OFF Sets the range of carriage movement.