MIMAKI UJV100-160 - Automatic Correction Sensor (DAS) Cleaning; Media Holder Cleaning

Chapter 4 Maintenance
96
4
Clean the media sensor.
5
Close the maintenance covers, then press the [ENTER] key.
Automatic Correction Sensor (DAS) Cleaning
The DAS sensor is located on the carriage underside. If dust or debris accumulates on the sensor, an error
may occur in the automatic correction function (Automatic correction of dot landing position). Remove any
debris using cotton swabs or a soft cloth.
1
In LOCAL mode, select [MENU] > [Maintenance], then press the [ENTER] key.
• The Maintenance menu is displayed.
2
Select [Station] > [Carriage Out] > [Move To Maint. Space], then press the [ENTER] key.
• The carriage moves to the maintenance space.
3
Open the maintenance covers.
4
Clean the DAS sensor.
5
Close the maintenance covers, then press the [ENTER] key.
Media Holder Cleaning
• Turn off the main power and unplug the power cable before carrying out maintenance.