MIMAKI UJV100-160 - Page 73

Chapter 3 Settings
73
Item Setting Details
*1 *2
• OFF: Machine size area
Unidirectional print Bi-directional print
Carriage movement
• ON: Print data area
Unidirectional print Bi-directional print
Print data
Carriage movement
OVER PRINT HOST/1 to 2
times
1 Sets the number of overprinting.
Margin/Left HOST/-10 to
85 mm
0
mm
Sets the offset value from the media left and right standard
margins (15 mm).
• The left and right margins should be set to at least -5 mm when
using the media holder. This eliminates the risk of printing on top
of the media holder.
• The Mimaki RIP software (RasterLink) does not allow the user to
specify margins. If the machine is set to “HOST”, the offset value
will be “0 mm” for the left and right margins.
Margin/Right
Vacuum HOST/Weak/
Standard/
Strong
Stro
ng
Sets the force with which the medium is held down.
• This can be used to prevent media jamming and print head
damage caused by the media lifting up.
Feed Speed
*3
HOST/10 to
100 to 200 %
100
%
Sets the media feed speed.
• Depending on print conditions, the speed may not vary for
certain settings.
Auto Cleaning - - Sets the conditions to perform auto head cleaning after the
preset number of files are printed.
SETUP File/Length/
Time/OFF
- Sets the conditions to perform auto head cleaning.
Interval - - Sets auto head cleaning intervals.
(File) 1 to 1,000 - Sets the interval at which the number of files is selected.
(Length) 0.1 to 100.0 m - Sets the interval at which the print length is selected.
(Time) 10 to 120 min - Sets the interval at which the print time is selected.
Type Normal/Soft/
Hard
- Sets the head cleaning type.
Cleaning Check ON/OFF - Sets whether nozzle checking is performed after auto head
cleaning is completed.
UV mode ON/OFF/
NoPrint
ON Sets whether to turn on or off the UV-LED lamp.
• ON: Turns on the UV-LED lamp.
3