Chapter 3 Settings
74
Item Setting Details
*1 *2
• OFF: Turns off the UV-LED lamp.
• No print: Turns on the UV-LED lamp without printing. (Not used
under ordinary conditions)
MAPS4 - - MAPS: Mimaki Advanced Pass System
• This function disperses the boundaries between passes to make
feed streaks between passes less visible.
• Altering MAPS may alter the color. This function may be less
effective with certain types of images.
MAPS4 AUTO/
MANUAL/OFF
- This should normally be set to “AUTO”. When set to
“MANUAL”, the following items are displayed:
Smoothing
Level
0 to 100 % - Increasing smoothing makes streaks less visible.
• Make separate settings for color ink (color) and white ink (spot)
when using white ink.
Speed 50 to 100 % - Reducing speed will make streaks less visible. However,
printing will be slower.
Expansion ON/OFF - Selecting “ON” will make streaks less visible. However, it may
increase visible grain.
Ionizer
*4
ON/OFF - Sets the ionizer (optional). For more information, refer to the
operating manual for the ionizer.
Setup Reset - - Initializes the details set.
*1. The default settings are shown underlined.
*2. Settings applied if no settings can be made in the RIP software (host) or if this machine is prioritized.
*3. Setting to 100 % or more reduces the time required to complete printing but may affect print quality due to
insufficient drying time.
*4. Displayed when an option is connected.
Changing the name of a setting type
You can change the name of a setting type. The name can include alphanumeric characters or symbols.
1
In LOCAL mode, select [MENU] > [Setup], then press the [ENTER] key.
• The setting types are displayed.
2
Select Settings 1 to 4 and press the [FUNC2] key.
• The rename screen appears.
3
Enter the desired name, then press the [ENTER] key.
• The setting type is renamed.
To Next Page
Loading...
