Chapter 4 Maintenance
99
7
Press the [ENTER] key once cleaning is complete.
• “Fill the Liquid. Exit Next [ENT]" appears on the display.
8
Fill the cap with washing liquid.
• Use a syringe to draw up some washing liquid and fill until it almost overflows from the cap.
9
Close the front cover, then press the [ENTER] key.
• Print nozzle washing starts. The elapsed time is displayed on the display. Nozzle washing takes
approximately one minute.
• Cleaning is performed automatically once print nozzle washing has ended.
• “Fill the Liquid. Exit Next [ENT]” appears on the display when print nozzle washing is complete.
10
Fill the cap with washing liquid.
• Use a syringe to draw up some washing liquid and fill until it almost overflows from the cap.
11
Close the front cover, then press the [ENTER] key.
• Pump tube (ink discharge channel below the cap) washing starts.
4
To Next Page
Loading...
