Accutorr V Operating Instructions 0070-10-0699-02 3 - 25
Operation Common Setup
4. Once the desired value is displayed, press (18) to set it
5. Repeat steps 1 through 4 as needed.
6. Once the contrast or brightness values are set, either:
• (12) to exit the COMMON SETUP dialog.
• Set the alarm, key, or pulse volume (refer to Section 3.10.1).
NOTE: Any changes made to LCD BRIGHT and LCD CONTRAST
remain when the monitor is turned off and then on again.
NOTE: There is no setting item “LCD CONTRAST” on the color LCD
display.
To Next Page
Loading...
