D - 14 BeneVision N Series Patient Monitor Operator’s Manual
D.2.22 Printer Technical Alarm Messages
D.2.23 Technical Alarm Messages Related to Networked Monitoring
Recorder Head Hot Low C The recorder has been working for too long time.
Stop the recording and resume the recording till
the recorder’s print head cools down.
Recorder Initializing Prompt / Wait until the recorder initialization is completed.
Recorder out of Paper Prompt / The recorder paper is not loaded or the recorder
door is not closed. Check the recorder, load the
recorder paper or close the recorder door.
Recorder Busy Prompt / The buffer queue for recording is full.
Recorder Not Exist Prompt / The recorder module is not plugged. Plug the
module.
Alarm message Default priority
Indication on
alarm reset
Cause and solution
Alarm message Default priority
Indication on
alarm reset
Cause and solution
Printer Buffer Full Prompt / The printer buffer is full. Wait till the printer
finishes the printing task.
Fail Prompt / The printer runs out of paper or cannot be
connected. Check the printer.
Printing Stopped Prompt / Printing is manually stopped.
Printer Unavailable Prompt / The printer may fail. Check the printer.
PDF storage space is
nearly full
Prompt / Delete the files saved under the PDF file path to
release storage space. Otherwise you cannot save
new PDF files.
Error storing PDF file Prompt / The PDF file path settings on the printer server
and the PDFCreator are not consistent or the PDF
storage space is full. Check the PDF file path
settings for consistency, or delete the files saved
under the PDF file path to release storage space.
Change the print server
language to be consistent
with this monitor
Prompt / Verify that the language settings of the printer
server and the monitor are consistent, Otherwise
you cannot perform printing.
Print Server Disconnected Prompt / Check that the monitor is properly connected
with the printer server.
Alarm message Default priority
Indication on
alarm reset
Cause and solution
No CMS Low B The monitor is disconnected from the CMS.
Check the network connection.
View Bed XX YY-ZZ,
Network Disconnected.
Low A The network is interrupted when the monitor is
viewing the remote device. Check the network
connection.
Viewed by Bed XX YY-ZZ,
Network Disconnected.
Low A The network is interrupted when the monitor is
viewed by another remote device. Check the
network connection.
WLAN IP Address Conflict Low C Wireless network IP network conflicts. Check the
network settings.
To Next Page
Loading...
