Mindray BeneVision N17 - Using the Remote Controller; Screen Display

BeneVision N Series Patient Monitor Operator’s Manual 3 - 5
NOTE
• Contact the scanner manufacturer or Mindray to obtain the engineering barcodes for clearing data
formats and containing the hospital’s data format.
3.5.6 Using the Remote Controller
You can use the remote controller to control the monitor by connecting the receiver of the remote controller to
the monitor’s MSB connector (for N22/N19) or the USB connector (N17/N15/N12/N12C). For more information
on how to use the remote controller, see the Instructions for Use delivered with the remote controller.
3.6 Screen Display
The following figure shows the normal screen:
(1) (2) (3) (4) (5)
(9)
(6)
(7)
(8)
(1) Patient information area: displays patient information, including patient category, gender, department, room
number, bed number, and so on. The displayed patient information is configurable. Selecting this area enters the
Patient Management menu. For more information, see 5.4Managing Patient Information.
(2) The current configuration
(3) Technical alarm information area: displays prompt messages on the above; displays technical alarm messages at
the bottom.
(4) Physiological alarm information area: displays high priority physiological alarms on the above; displays medium
and low priority physiological alarms at the bottom.
(5) System status information area: displays alarm symbol, battery status, network status, currently connected CMS,
storage device status, and system time. For more information, see 3.6.1On-screen Symbols.
(6) Parameter waveform area: displays parameter waveforms and parameter alarms. Select a waveform enters
corresponding parameter menu. For more information, see 3.11.3Displaying the Parameter List.
(7) Parameter numerics area: displays parameter values, alarm limits, and alarm status. This area also displays
parameter list. Selecting a parameter numeric block enters corresponding parameter menu. Selecting the
parameter list enters tabular trend review. For more information, see 3.11.3Displaying the Parameter List.
(8) Parameter waveform/numerics area: displays parameter waveforms, parameter values, alarm limits, and alarm
status. Selecting a parameter numeric area or waveform area enters corresponding parameter menu. For more
information, see 3.11.3Displaying the Parameter List.