C-8 Description of Self Test Items
◼ Suggestion to failure test
Restart the device to perform the self test if the test result appears Error. It is necessary to restore
the device (OS+doppler) if Error re-appears.
It is recommended to change TRB board if the test result is FAIL.
C.1.19 Z0503 TRB AFE Digital Interface Test
◼ Top test item
TRB AFE SPI test
◼ Test content
Enter system test mode, write the data to TRB AFE, input delay RAM, re-read the data from
delay-channel memory to locate the channel and AFE clip.
◼ Analysis to test failure
The drive goes wrong if the test result appears Error.
AFE clip goes wrong if the test result is FAIL.
◼ Suggestion to failure test
Restart the device to perform the self test if the test result appears Error, which indicates the logic
error of DSP FPGA occurs. It is necessary to restore the device (OS+doppler) if Error re-appears.
It is recommended to change TRB board if the test result is FAIL.
C.1.20 Z0504 TRB Transmission and Reception Function
Test
◼ Top test item
TRB AFE test mode
◼ Test content
Test the coherence of 64 channels in transmitting and receiving: one channel transmits 2 V 1 M
PHV1 waveform each time, and analyzes whether the waveform is PHV1, and compares the
signal-to-noise ratio of this channel with others’.
◼ Analysis to test failure
The drive goes wrong if the test result appears Error.
The waveform that the channel transmits is incorrect if the information “Open circuit of transmitting
and receiving channel: XXX” appears.
The transmission of this channel affects other channels if the information “Short circuit of
transmitting and receiving channel” appears.
◼ Suggestion to failure test
Restart the device to perform the self test if the test result appears Error. It is necessary to restore
the device (OS+doppler) if Error re-appears.
It is recommended to replace TRB board if the test result is FAIL.
C.1.21 Z0505 DSP FPGA and TRB Interconnection Test
(Data Interface)
◼ Top test item
DSP FPGA and TRB FPGA communication self test (control interface)