Image Optimization 5-27
Change the trace area through the [Trace Area] item in the soft menu or
menu.
The available selections of trace area are: Above, Below, All.
Trace
Smooth
To set the smooth level when tracing.
Change the effect through the [Trace Smooth] item in the soft menu or
menu.
There are 5 levels of smooth effect provided, the bigger the value, the
higher the smooth processing.
Trace
Sensitivity
This function is used to set the sensitivity of tracing in the spectrum.
Adjust through the [Trace Sensitivity] item in the soft menu or menu.
There are 6 levels of sensitivity adjustment, the bigger the value the higher
the sensitivity.
V Max & V
Mean
To display maximum speed and average speed in the spectrum
automatically.
Click [V Max] or [V Mean] in the soft menu or menu to turn on or off the
function.
In the spectrum map, maximum speed is displayed in red curve, while the
average speed is displayed in blue curve.
Impacts The function is available in real-time imaging, freeze or cine review status.
Gray Map
Description
This function applies the gray correction to obtain the optimum image.
Operation Select among the maps through the [Gray Map] item in the soft menu or
menu.
There are 8 different gray maps available.
Impacts The function is available in real-time imaging, freeze or cine review status.
Display Format
Description
To set the display format of PW mode image with B mode image.
Operation Adjust through the [Display Format] item in the soft menu or menu.
There are 4 formats to display the images: V1:1, L/R, V1:2, Full.
Impacts The function is available in real-time imaging, freeze or cine review status.
Duplex/ Triplex
Description
This function is used to set if B image (B+Color image) and PW image are
displayed synchronously.
Operation Turn on or off the function through the [Duplex] / [Triplex] in the soft menu
or menu.
Impacts The function is available in real-time imaging, freeze or cine review status.
To Next Page
Loading...
Need help?
General
