Batteries 16-3
To remove the batteries:
1. Turn off the system, and disconnect the adapter from the main unit.
2. Close the monitor, turn the system upside down and put it on the table.
3. Push the buckles located between the two bays to unlock the batteries.
4. Take out the batteries from the bays.
16.4 Battery Status Indicator
The battery status indicator is located in the lower right corner of the screen, indicating the
battery capacity.
：Indicates the battery capacity is empty.
：Indicates the battery capacity is full.
The battery icons other than the two icons above-mentioned indicate the capacity
is between empty and full.
When the power capacity is not enough, the system will pop up a prompt:
“Warning! Battery is out of power! Please insert the Adapter or system will be shut down in
one minute.” Connect the power adapter to afford normal work.
16.5 One Full Discharge /Charge Cycle
Upon receipt of the system and before first time usage, it is recommended that you
perform one full discharge /charge cycle. If the battery has not been used for over 2
months, you are recommended to perform one full discharge /charge cycle. It is also
recommended that the battery is stored in the shady and cool area with FCC (full current
capacity).
One Full Discharge / Charge Cycle:
1. Full discharge of the battery to let the system automatically shut down.
2. Charge the system to 100% FCC (full current capacity).
3. Discharge of the system for complete shutdown.
To Next Page
Loading...
Need help?
General
