Mindray TE7 - Page 86

5-24 Image Optimization
Tint Map
Description
This function provides an imaging process based on color difference rather than
gray distinction.
Operations
Select maps or turn on/off the function by using [Tint Map] control.
There are 8 color effect maps available.
Gray Map
Description
This function applies the gray correction to obtain optimum images.
Operations
Select maps by using [Gray Map] control.
There are 10 gray effect maps available.
Display Format
Description
To set the display format of PW mode images with B mode images.
Operations
Select different layout through [Display Format].
There are 4 formats for displaying the images: V2:3, V3:2, V3:1, Full.
Duplex/Triplex
Description
This function is used to set whether a B image (B + Color image) and PW image
are displayed synchronously.
Operations
Select [Duplex]/[Triplex] to turn the synchronization on or off.
HPRF
Description
HPRF mode is used when detected velocities exceed the processing capabilities
of the currently selected PW Doppler scale, or when the selected anatomical site
is too deep for the selected PW Doppler scale.
Operations
Turn the function on or off using the [HPRF] control.
Effects
HPRF enhances the range for detecting high-velocity flow.
Baseline
Description
Refers to the area where the velocity is zero in the spectrum.
Operations
Tap and drag the green baseline on the spectrum to change the position.
Effects
Changes the flow-velocity range to optimize the image.