Mindray VS-900 - Disassembly and Repair; Tools, Preparations, and Main Unit Steps; Parts Identification; Main Unit and Front Housing Parts

To Next Page

To Previous Page

6.3.2 Disassembling the Infrared Ear Thermometer Module (Optional) .............................. 6-2

6.3.3 Removing the Recorder ............................................................................................................... 6-3

6.3.4 Separating the Front and Rear Half of the Monitor ........................................................... 6-3

6.3.5 Removing the Parameter Connector Panel Assembly ..................................................... 6-5

6.3.6 Disassembling the Main Bracket Assembly .......................................................................... 6-6

6.3.7 Removing the Parameter Board (SpO

Optional) and Power Management Board6-8

6.3.8 Removing the Parameter Connector Panel Assembly (With CO

) ............................... 6-9

6.3.9 Disassembling the CO

Module Assembly ..........................................................................6-10

6.3.10 Disassembling Pumps and Valves (NIBP optional) ........................................................6-10

6.3.11 Disassembling CO2 main Module .......................................................................................6-11

6.3.12 Disassembling the Main Bracket Assembly（With CO

） .........................................6-12

6.3.13 Disassembling Pumps and Valves (NIBP optional) ........................................................6-13

6.3.14 Disassembling AC/DC Power Board and Battery Converter Board .........................6-13

6.4 Disassembling the Front Housing Assembly ..................................................................................6-14

6.4.1 Removing the Touchscreen Control Board (Optional) ...................................................6-14

6.4.2 Removing the Wi-Fi Module (Optional) ...............................................................................6-15

6.4.3 Removing the Main Control Board ........................................................................................6-17

6.4.4 Removing SD Card (Optional) .................................................................................................6-18

6.4.5 Removing the Touchscreen (Optional) ................................................................................6-18

6.4.6 Disassembling the Display ........................................................................................................6-19

6.4.7 Removing the Keypad ................................................................................................................6-19

6.4.8 Removing the Encoder ...............................................................................................................6-19

6.4.9 Removing the Alarm Lamp .......................................................................................................6-20

6.5 Disassembling the SmarTemp

Module (Optional) ....................................................................6-20

6.5.1 Removing the SmarTemp

Module PCBA and SmarTemp

Module Power Board

PCBA ............................................................................................................................................................6-20

6.5.2 Disassembling the Temp On-Position Detection Board PCBA ....................................6-21

6.6 Disassembling the Infrared Ear Thermometer Module (Optional) .........................................6-22

6.6.1 Disassembling the Pop-up Unit ..............................................................................................6-22

6.6.2 Disassembling the Separator Plate PCBA ...........................................................................6-23

6.6.3 Disassembling the Convidien Infrared Ear Thermometer Module or Exergen

TemporalScanner Themometer Module (Optional) ..................................................................6-24

7 Parts ........................................................................................................................................ 7-1

7.1 Introduction ................................................................................................................................................... 7-1

7.2 Main Unit ........................................................................................................................................................ 7-1

7.2.1 Exploded View ................................................................................................................................. 7-1

7.2.2 Parts List ............................................................................................................................................. 7-2

7.3 Front Housing Subassembly (Touchscreen) ...................................................................................... 7-2

7.3.1 Exploded View ................................................................................................................................. 7-2

7.3.2 Parts List ............................................................................................................................................. 7-3

7.4 Front Housing Subassembly (Non-Touchscreen) ............................................................................ 7-4

7.4.1 Exploded View ................................................................................................................................. 7-4

7.4.2 Parts List ............................................................................................................................................. 7-4