6. Operating | 6.2 - Configuration and adjustment via the keypad | 137
EtherNet IP
[Fieldbus] dEUnEt
[DHCP] dHCP
Selection: on, oFF
on = DHCP is activated. The network address is assigned automatically.
off = if DHCP is not activated, the addresses must be input manually.
[IP address] IP-Adr
Input higher-value part of the address: 192.168 (example)
Input lower-value part of the address: 185.000 (example)
[Subnet mask] SubnEt
Input higher-value part of the address: 255.255 (example)
Input lower-value part of the address: 254.000 (example)
ProfiNet I/O
[Fieldbus] PronEt
[IP address] IP-Adr
Input higher-value part of the address: 192.168 (example)
Input lower-value part of the address: 185.000 (example)
[Subnet mask] SubnEt
Input higher-value part of the address: 255.255 (example)
Input lower-value part of the address: 254.000 (example)
6. Press "Exit" to exit the setup menu.
7. Save the changes.
6.2.16 Displaying system information
1. Press and hold for 2–3 seconds.
SEtuP appears on the display.
2. Press "OK".
Cd 000 appears on the display (Cd flashes).
3. Select the individual parameters and modify if required, see Chapters
Parameter table (setup) and Selecting parameters.
[Software version] IF 090 Soft.Ve
Display: Software Version
[Interface] IF 091 Slot
Display: EMPtY or PR 5310 card type
[RS-232 interface] IF 092 Rs-232
Display: none, printer, remote display, SMA, ModBus-RTU
To Next Page
Loading...
