Minebea Intec PR 5310 - Mechanical Installation Procedures

4. Device installation | 4.2 - Mechanical preparation | 29
4.2 Mechanical preparation
4.2.1 Storage and transport conditions
NOTICE
Material damage is possible.
Unpacked devices may lose their precision due to strong vibrations; strong
vibrations may impair the safety of the device.
Do not subject the device to extreme temperatures, moisture, shocks, and
vibrations.
4.2.1.1 Storage temperature
Storage temperature range: –20…+70°C
4.2.1.2 Transport conditions
The packaging for transportation of MinebeaIntec devices was designed to
avoid transport damage. It is recommended that the box and all parts of the
packaging should be kept for future storage or transportation of the device.
To avoid damage to the device, all cables must be removed before packaging
it for transportation.
4.2.2 Installation location
Avoid unsuitable influences at the installation location:
– Extreme temperatures and excessive temperature fluctuations (see Chap
terAmbient conditions)
– Heat due to proximity to heaters or due to direct sunlight
– Aggressive chemical vapors
– Extreme moisture (see ChapterAmbient conditions)
– Extreme vibrations (see ChapterAmbient conditions)
4.2.3 Unpacking
Unpack the device and check it for visible external damage.
If there is damage, follow the instructions in ChapterSafety
inspection.
Keep the original packaging in case the device needs to be returned.
Remove all cables before sending.