Minebea Intec PR 5310 - Selecting Parameters

6. Operating | 6.1 - Operating and display elements | 90
Menu/navigation keys
Key Function
Setup Menu
Access the setup menu.
Exit Exit
Exit the current menu.
OK Confirm
Confirm input/selection.
Cursor left
– Cursor to the left
– Selection
Cursor down
Scroll down in the menu.
Cursor up
Scroll up in the menu.
Cursor right
– Cursor to the right
– Selection
6.1.3 Selecting parameters
1. Press and hold for 2–3 seconds.
SEtuP appears on the display.
2. Press "OK".
Cd 000 appears on the display (Cd flashes).
3. Press to navigate to the next parameter group.
4. Press to navigate to the parameter number.
The parameter table is described in Chapter Parameter table (setup).
All parameters/data are unambiguously identified by a max. 3-digit
number. This is also preceded by two letters for the parameter group for
ease of assignment.