6. Operating | 6.3 - Other functions via keypad | 138
[RS-485 interface] IF 093 Rs-485
Display: none, printer, remote display, SMA, ModBus-RTU
[Battery status] IF 094 Rtc.bat
Display: OK bAt oK, not OK bAt nOt oK
4. Press "Exit" to exit the setup menu.
6.2.17 Printing configuration data
Note:
Printing is only possible if a printer is connected, see Chapter Configuring
the serial interface for the printer.
1. Press and hold for 2–3 seconds.
SEtuP appears on the display.
2. Press "OK".
Cd 000 appears on the display (Cd flashes).
3. Press (15×) to select PP 110.
4. Press "OK".
rESEt? appears on the display.
5. Press "OK" to print the configuration data.
Err 90 appears on the display if no printer is connected.
6.3 Other functions via keypad
6.3.1 Testing the front-panel keys
1. Press and hold for 2–3 seconds.
SEtuP appears on the display.
2. Press / .
tESt appears on the display.
3. Press "OK".
kEy appears on the display.
To Next Page
Loading...
