Minebea Intec PR 5310 - 3 Device Description; Key Features and Interfaces

3. Device description | 16
3 Device description
3.1 General information
The indicator is equipped with a six-digit 7-segment display and additional
status indication. Local operation is performed using 6double-function keys.
3.2 Overview of the device
– Accuracy 6,000d (acc. to OIML R76 ClassIII) for the weighing electronics
– High-speed conversion with response times from upto 5ms
– Weight indication with status by transflective 6-digit 7-segment display
– 6function keys for front-panel operation
– Protection class panel version: Front panel and housing rated to IP65,
rear panel rated to IP30
– Protection class stainless steel version: IP65
– RS-232 interface, built-in for connecting e.g. a printer or a remote display
– RS-485 interface, built-in for communication e.g. ModBus
– 3 internal passive opto-decoupled inputs
– 3 relay outputs
– Expansion of the instrument is not possible. When ordering, the possible
equipment is determined, see ChapterOrder information
– Analog output
– ProfiBus-DP
– DeviceNet
– EtherNet/IP
– ProfiNet I/O
– Galvanically isolated interfaces (except RS-232, RS-485)
– Version for U
DC
=24V
– Panel device: plug-in connections are on the rear panel for load cells, in
puts/outputs, serial interfaces
– Table-top device: plug-in connections are on the rear panel for load cells,
inputs/outputs, serial interfaces via cable glands
– Calibration using front keys
– Calibration using weights, by entering mV/V values or directly, using load
cell data (SMART Calibration)
– Software configuration of the interface cards, e.g. for remote display or
printer
– Analog test for the weighing electronics
– Overwrite protection:
– via CAL switch