Minebea Intec PR 5310 - Page 59

4. Device installation | 4.3 - Hardware construction | 59
Technical data
Name Data
Inputs
Number of inputs 3 (CH 1, CH 2, CH 3)
Input supply voltage Logic0: U
DC
=0…5V or open
Logic1: U
DC
=10…28V
Passive, external power supply required
Input current <7mA @ 24V
<3mA @ 12V
Protection against incorrect polarity
Input frequency Max. 200Hz (50% ratio)
Potential isolation Yes, via optocoupler
Outputs
Number of outputs 3 (CH 1, CH 2, CH 3)
Output Change-over contact
Max. switching voltage:
U
DC
=31V/U
AC
=24V
Max. switching current:
1A
Switching frequency Max. 10Hz
Potential isolation Free relay two-way contact
Cable Connection
Cables Screened
Cable screen must be connected to the housing
at the rear wall or in the cable gland.
Cable length max. 50m
Connections
Internal connection Contact strip
External connection Plug connector, 26-pin